LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

    WARNING: Refer to SIR Warning .
  1. Disable the SIR system SIR Disabling and Enabling .
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement .
  3. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
    4. Fig 1: Disconnecting/Reconnecting Theft Deterrent Control Module Connector
    GM420192Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the theft deterrent control module connector.
  5. Disconnect the fused jumper assembly connector.
    6. Fig 2: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  6. Slide the theft deterrent control module (2) from the ignition lock cylinder case (1).
    7. Fig 3: View Of Ignition Lock Cylinder Case, Ignition Switch, Retaining Screws & Key Alarm Connector
    GM324871Courtesy of GENERAL MOTORS CORP.
  7. Remove the key alarm connector (1) from the ignition lock cylinder case (4).
  8. Remove the 2 tapping screws (3) from the ignition switch assembly (2).
scientia non olet · About LEMON Manuals