Vehicle Input Speed Sensor Replacement

Vehicle Input Speed Sensor Replacement

Removal Procedure




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Disconnect the input speed sensor (1) electrical connector.
3. Remove the input speed sensor bolt.
4. Remove the input speed sensor (1) and the bracket assembly from the case.
5. Inspect the vehicle speed sensor assembly (1) for any evidence of damage.

Installation Procedure




1. Lubricate the input speed sensor seal with automatic transmission fluid.
2. Install the input speed sensor (1) and the bracket assembly.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the bolt and tighten to 11 Nm (96 lb in).
4. Connect the input speed sensor electrical connector.
5. Lower the vehicle.