LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2008 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension Control System - Automatic Level Control >> Repair Instructions >> Automatic Level Control Sensor Link Ball Stud Replacement (Twist Axle) >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Locating Automatic Level Control Sensor Link Ball Stud
    GM380438Courtesy of GENERAL MOTORS CORP.
  1. Install the ball stud to the rear axle tie rod.

    Tighten:  Tighten the height sensor ball stud to 12 N.m (106 lb in).

  2. Install the automatic level control sensor link to the tie rod ball stud.
  3. Lower the vehicle.
  4. Install the ELC/TRAILER fuse.
scientia non olet · About LEMON Manuals