Circuit/System Verification
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected.
- PPS module
- PPS module wiring harness
- SDM
- SDM wiring harness
- Verify that DTC B0081 39 is not set.
- If the DTC is set, replace the PPS module.
- Verify the correct SDM and PPS module part number are installed for the vehicle configuration.
- If incorrect SDM or PPS module are installed, replace with the correct module.
- Verify that no PPS DTCs are present. Refer to Passenger Presence System Flash Code Procedures .
- If PPS DTC's are present, refer to Diagnostic Trouble Code (DTC) List - Vehicle for the appropriate DTC diagnostic procedure.
- Ignition ON, verify the appropriate inflatable restraint passenger air bag ON/OFF indicator illuminates.
- If the appropriate inflatable restraint passenger air bag ON/OFF indicator does not illuminate, refer to Passenger Presence System Indicator Circuit Malfunction .
- Verify that DTC B0081 is not set as current.
- If DTC is set as current, replace the PPS module.