LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 896 (Cruise Control System) >> Diagnostic Information and Procedures >> Cruise Control Malfunction >> Component Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Component Testing

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The cruise control switch must be ON in order to properly measure the resistance of the - /SET, +/RES, switches.
  1. Disconnect the harness connector at the steering wheel control switch - left.
  2. Connect a DMM between terminals 4 and 5 of the steering wheel control switch - left.
  3. Cruise control switch ON, measure the resistance while individually activating and holding each cruise control function switches and compare the resistance reading to the values in the table for the appropriate switch.
    • If any of the resistance measurements for the individual switches are not within the specified resistance values, replace the steering wheel control switch-left.
Function Switch Minimum Resistance Value Maximum Resistance Value
Off O.L. O.L.
On 7.8k Ohms 8.6k Ohms
- SET 1.2k Ohms 1.4k Ohms
+ RES 2.8k Ohms 3.0k Ohms
scientia non olet · About LEMON Manuals