October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Electronic Brake Control Module Replacement
WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP. Electronic Brake Control Module Replacement
| Callout |
Component Name |
|
NOTE:
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
Preliminary Procedures
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation
.
- Remove the left front inner wheelhouse liner. Refer to Front Wheelhouse Liner Replacement
.
|
| 1 |
Bolts, Electronic Brake Control Module (Qty: 4)
Tighten:
3 N.m (27 lb in)
|
| 2 |
Module, Electronic Brake Control
Tip:
- Clean the sealing surface of the brake pressure modulator valve with denatured alcohol and a clean shop cloth.
- Disconnect the electrical connector from the electronic brake control module.
- If a new electronic brake control module is installed, program the electronic brake control module. Refer to Service Programming System (SPS)
.
- If a new electronic brake control module is installed, program the electronic brake control module. Refer to Control Module References
.
|