LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Automatic Level Control Sensor Link Ball Stud Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ELC/TRAILER fuse.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Locating Automatic Level Control Sensor Link Ball Stud
    GM380438Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When removing the link, do NOT bend or break the sensor arm.
  3. Remove the automatic level control sensor link from the rear suspension ball stud.
  4. Remove the ball stud from the rear suspension.
scientia non olet · About LEMON Manuals