LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Automatic Level Control Sensor Link Ball Stud Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Fastener Notice .
    Fig 1: Locating Automatic Level Control Sensor Link Ball Stud
    GM380438Courtesy of GENERAL MOTORS CORP.
  1. Install the ball stud to the rear suspension.

    Tighten:  Tighten the height sensor ball stud to 4 N.m (35 lb in).

  2. Install the automatic level control sensor link to the rear suspension ball stud.
  3. Lower the vehicle.
  4. Install the ELC/TRAILER fuse.
scientia non olet · About LEMON Manuals