Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Torrent and 2006 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing PRNDL Assembly Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Align the PRNDL assembly with the trim bezel and fasten in place.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Connect the electrical connector to the PRNDL assembly.
Install the I/P trim bezel. Refer to Trim Bezel Replacement - Center in Instrument Panel, Gages and Console.
Test the PRNDL assembly for proper operation.