Installation Procedure

Fig 1: Routing Cruise Control Cable From Cruise Control Module To Throttle Body

Courtesy of GENERAL MOTORS CORP.

Route the cruise control cable (4) from the cruise control module (3) to the throttle body.

Fig 2: Removing All Bends & Twists From Cruise Control Module Ribbon & Cable

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not twist the cruise control module ribbon.

Remove all bends and twists from the cruise control module ribbon and cable, by rotating the ribbon.
Pull the cruise control cable from the throttle linkage end until the cable is taut.
Install the cable bead to the buckle on the end of the ribbon on the cruise control module.

Fig 3: Cruise Control Cable & Cruise Control Module

Courtesy of GENERAL MOTORS CORP.

Check the orientation of the cruise control ribbon buckle to the cable end fitting.
Snap the cruise control cable fitting into the cruise control module.

Fig 4: Cruise Control Cable & Cable Bracket

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Verify that the cable fitting locking tabs are expanded, and that the tabs are locked in the bracket hole.

Fig 5: Cruise Control Cable End And Throttle Linkage

Courtesy of GENERAL MOTORS CORP.

Connect the cruise control cable end (2) to the throttle linkage (1).
Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment .
Install the air cleaner assembly. Refer to the following procedures:
- Air Cleaner Assembly Replacement for the 4.3L engine
- Air Cleaner Assembly Replacement for the 4.8L, 5.3L, and 6.0L engine
Close the hood.