LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
    GM1544729Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor (2) to the air filter housing.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the MAF/IAT sensor (2) bolts.

    Tighten:   Tighten the ECT sensor to 10 Nm (89 lb in).

  3. Install air cleaner outlet duct . Refer to Air Cleaner Outlet Duct Replacement .
  4. Connect the engine harness electrical connector (1) to the MAF/IAT sensor.
  5. Start and idle the engine.
  6. Inspect the air intake duct for leaks.
scientia non olet · About LEMON Manuals