LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiper Motor & Screws
    GM815221Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor to the wiper drive system module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the wiper motor screws.

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

    3. Fig 2: Wiper Crank Arm & Nut
    GM1257438Courtesy of GENERAL MOTORS CORP.
  3. Install the wiper crank arm (1) to the wiper motor shaft.
  4. Install the wiper crank arm nut (2) to the wiper motor shaft.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

  5. Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
scientia non olet · About LEMON Manuals