LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Inflatable Restraint Front End Sensor Replacement

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Replacing Inflatable Restraint Front End Sensor
GM1544940Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Front End Sensor Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
CAUTION: Refer to SIR Caution .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling Zone 1 .
  2. Remove the upper air baffle and deflector. Refer to Radiator Air Baffle and Deflector Replacement - Upper .
  3. Remove both headlamps. Refer to HEADLAMP REPLACEMENT (IMPALA) or HEADLAMP REPLACEMENT (MONTE CARLO) .
  4. Remove the fascia grille support bolts, 8 total. DO NOT remove the bumper fascia. Refer to FRONT BUMPER ENERGY ABSORBER REPLACEMENT .
  5. Remove the retainers from fascia to grille support, 4 total.
  6. Pull the grille support forward to gain clearance to the sensors.
1 Bolt, Inflatable Front End Sensor Mounting (Qty: 2)

Tighten:  11 N.m (97 lb in)
2 Connector, Connector Position Assurance (CPA)
3 Sensor, Inflatable Front End
scientia non olet · About LEMON Manuals