LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Cruise Control System) >> Repair Instructions >> Clutch Pedal Cruise Control Release Switch Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Clutch Cruise Control Release Switch At Bracket
    GM71495Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch cruise control release switch to the bracket.
  2. Fully seat the switch to the bracket.

    Audible clicks will be heard while pushing the switch.

    3. Fig 2: Clutch Cruise Control Release Switch Electrical Connector
    GM71493Courtesy of GENERAL MOTORS CORP.
  3. Rotate the threaded switch to adjust it to the closed position when the clutch pedal is fully released.
  4. Connect the clutch cruise control release switch electrical connector.
  5. Secure the clutch pedal cruise control release switch wiring harness to a surrounding wiring harness.

    Ensure that operation of the clutch pedal does not contact the clutch pedal cruise control release switch wiring harness or cause the switch to rotate.

  6. Install the LH I/P lower insulator panel. Refer to Instrument Panel Insulator Panel Replacement .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (6.0L) or Battery Negative Cable Disconnection and Connection (7.0L) .
scientia non olet · About LEMON Manuals