Knock Sensor (KS) Replacement (Right)

KNOCK SENSOR (KS) REPLACEMENT (RIGHT)

REMOVAL PROCEDURE




1. Remove the right front tire and wheel assembly.
2. Remove the inner wheel well.




3. Remove the retaining bolt for the knock sensor (KS) (1).
4. Remove the KS (2).
5. Remove the electrical connector for the KS (3).

INSTALLATION PROCEDURE




1. Reconnect the KS electrical connector.
2. Position the KS on the engine block.
3. Install the retaining bolt for the KS.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the KS retaining bolt to 20 N.m (15 lb ft).




4. Install the right wheelhouse liner.
5. Install the right front tire and wheel assembly.