LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Antilock Brake System And Traction Control System) >> Diagnostic Information And Procedures >> DTC C0244 >> Test Description
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Test Description

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 3:  This step tests for voltage supplied to the ECM from the EBCM.
  2. 4:  This step tests for a shorted resistor in the EBCM or a short to voltage within the circuit, by verifying that a large voltage drop occurs in the circuit when the test lamp is placed in parallel with the DMM. The ECM may be damaged if either of these conditions is present.
DTC C0244

Step Action Values Yes No
Schematic Reference: ABS Schematics 
Connector End View Reference: ABS Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Use a scan tool in order to clear the DTCs.
  2. Turn OFF the ignition for 5 seconds.
  3. Start the engine.
Does the DTC set?		 - Go to Step 3  Go to Diagnostic Aids
3  Use the scan tool in order to monitor the delivered engine torque in the ABS data display.
Does the scan tool show a delivered engine torque value between 90-100 percent?		 - Go to Diagnostic Aids Go to Step 4 
4  Test the delivered torque signal circuit for an open or a short. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - - Go to Step 5 
5
  1. Disconnect the electronic brake and traction control module (EBTCM).
  2. Using a DMM measure the voltage on the delivered torque signal circuit.
Does the voltage measured equal the specified value?		 B+ Go to Step 8  Go to Step 6 
6
  1. Turn OFF the ignition.
  2. Inspect for poor connections at the harness connector of the electronic brake control module (EBCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 7 
7 Replace the EBCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 - Go to Step 10  -
8 Inspect for poor connections at the harness connector of the Engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 9 
9 Replace the ECM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 - Go to Step 10  -
10
  1. Use the scan tool Clear All Class 2 DTCs function to clear all of the DTCs from all modules.
  2. Turn OFF the ignition for 5 seconds.
  3. Turn ON the ignition.
  4. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 - Go to Step 3  System OK
scientia non olet · About LEMON Manuals