Coolant Leak Testing - Starter/Generator Control Module

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 24460-01 Cooling System Pressure Tester. See Special Tools .
J 46143 Cooling System Adapter. See Special Tools .

CAUTION: To avoid being burned, do not remove the starter/generator control module (SGCM) cap while the SGCM is hot. The cooling system will release scalding fluid and steam under pressure if the SGCM cap is removed while the SGCM is still hot.

Fig 1: View Of SGCM Coolant Inlet Hose, Coolant Tank & Inlet Hose Clamp

Courtesy of GENERAL MOTORS CORP.

Follow the steps below in order to remove the starter/generator control module (SGCM) coolant tank cap.
1. Slowly rotate the cap counterclockwise.
2. Stop rotating and allow the hissing to stop.
3. After all the hissing stops, continue turning counterclockwise in order to remove the cap.
Test the operation of the pressure cap. Refer to Pressure Cap Testing - Starter/Generator Control Module .
Wash the pressure cap mating surface with water.
Use the J 24460-01 with the J 46143 in order to apply pressure to the cooling system. See Special Tools .
IMPORTANT: Do not exceed the pressure cap rating.
The cooling system should hold the rated pressure for at least 2 minutes.
Observe the gage for any pressure loss.
Repair any leaks as required.