Exiting On-Board Diagnostics

When exiting the on-board diagnostics any DTCs stored by the rear side door actuator control module will be erased. In order to review the DTCs, diagnostic mode 1 may be entered from mode 3 by pressing the power sliding door open/close switch for 4 seconds. The on-board diagnostics may be exited from diagnostic modes 1 or 3 by turning power door on/off switch to the off position for a minimum of 10 seconds. After exiting the on-board diagnostics the power sliding door must be re-initialized. Refer to Power Sliding Door (PSD) Re-Initialization .