LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension Control System - Suspension Leveling >> Repair Instructions >> Automatic Level Control Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Install the automatic level control height sensor link onto the sensor arm.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the automatic level control height sensor to the vehicle.
    3. Fig 1: View Of Automatic Level Control Sensor
    GM881333Courtesy of GENERAL MOTORS CORP.
  3. Install the height sensor bracket bolts (1)

    Tighten:  Tighten the height sensor bracket bolts to 85 N.m (63 lb ft)

  4. Install the automatic level control height link to the tie rod ball stud. Refer to Automatic Level Control Sensor Link Replacement .
    5. Fig 2: View Of Automatic Level Control Height Sensor Electrical Connector
    GM881329Courtesy of GENERAL MOTORS CORP.
  5. Install the automatic level control height sensor electrical connector (1).
  6. Lower the vehicle.
  7. Perform a diagnostic system check. Refer toDiagnostic System Check - Automatic Level Control (With Inflator)  or Diagnostic System Check - Automatic Level Control (without inflator) .
scientia non olet · About LEMON Manuals