LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension Control System - Suspension Leveling >> Repair Instructions >> Automatic Level Control Air Compressor Head Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Route the wires through the tie strap and the conduit.
    2. Fig 1: Locating Automatic Level Control Air Compressor Head Components
    GM187229Courtesy of GENERAL MOTORS CORP.
  2. Install the O-ring (3) to the automatic level control air compressor.
  3. Install the air compressor head.
    4. Fig 2: Identifying Air Compressor Head Bolts Tightening Sequence
    GM187233Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the air compressor head bolts.

    Tighten:  Tighten the air compressor head bolts in the order shown to 6 N.m (53 lb in).

  5. Install the wiring to terminals B and C on the automatic level control air compressor electrical connector.
  6. Install the air dryer to the automatic level control air compressor. Refer to Automatic Level Control Air Dryer Replacement .
  7. Install the automatic level control air compressor to the vehicle. Refer to Air Compressor Replacement .
scientia non olet · About LEMON Manuals