LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Tracker RWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System - 2.0L (Introduction) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Install the KS (1) to the engine block.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the KS to the engine with the bolt.

    Tighten:  Tighten the bolt to 23 N.m (17 lb ft).

  3. Connect the KS electrical connector.
    4. Fig 1: View Of Knock Sensor
    GM728048Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals