Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector (3) to the recirculation actuator (2).
- Install the recirculation actuator (2).
- Install the 3 screws (1) to the recirculation actuator (2).
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
- Install the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.