LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Adjustable Pedal System) >> Repair Instructions >> Accelerator Pedal Bracket Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Nuts Attaching Adjustable Accelerator Bracket To Cowl
    GM1241586Courtesy of GENERAL MOTORS CORP.
  1. Install the adjustable accelerator bracket to the vehicle.
    NOTE: Refer to Fastener Notice .
  2. Install the 3 adjustable accelerator bracket nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

    IMPORTANT: Ensure that the adjustable accelerator pedal and adjustable brake pedal are synchronized in the full rearward position.
  3. Install the NEW cable. Refer to Brake Pedal Adjuster Actuator Cable Replacement .
  4. Install the accelerator pedal to the vehicle. Refer to Accelerator Pedal Assembly Replacement .
  5. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About LEMON Manuals