LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Power Steering Pump & Power Steering Pressure Hose
    GM65356Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pressure hose (2) to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the power steering pressure hose (2) to the power steering gear.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  3. Install the power steering pressure hose (2) to the power steering pump (1).

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  4. Lower the vehicle.
  5. Bleed the power steering system. Refer to Bleeding the Power Steering System .
scientia non olet · About LEMON Manuals