Installation Procedure

Route the cruise control cable (4) from the cruise control module (3) to the throttle body.

Fig 1: Routing Cruise Control Cable From Cruise Control Module To Throttle Body

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not twist the cruise control module ribbon.

Remove all bends and twists from the cruise control module ribbon and cable, by rotating the ribbon.

Fig 2: Removing All Bends & Twists From Cruise Control Module Ribbon & Cable

Courtesy of GENERAL MOTORS CORP.

Pull the cruise control cable from the throttle linkage end until the cable is taut.
Install the cable bead to the buckle on the end of the ribbon on the cruise control module.

Fig 3: Installing Cable Bead To Buckle On End Of Ribbon On Cruise Control Module

Courtesy of GENERAL MOTORS CORP.

Check the orientation of the cruise control ribbon buckle to the cable end fitting.
Snap the cruise control cable fitting into the cruise control module.

IMPORTANT: Verify that the cable fitting locking tabs are expanded, and that the tabs are locked in the bracket hole.

Fig 4: Installing Cruise Control Cable Fitting Into Hole In Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Fig 5: Connecting Cruise Control Cable End To Throttle Linkage

Courtesy of GENERAL MOTORS CORP.

Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment .
Install the air cleaner assembly. Refer to the following procedures:
- Air Cleaner Assembly Replacement in Engine Controls - 4.3L.
- Air Cleaner Assembly Replacement in Engine Controls - 4.8L, 5.3L, and 6.0L.
Close the hood.