LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> Venture LT, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Replacement >> Installation Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Installation Procedure

  1. Install the reservoir to the pump.
  2. Install the power steering pump pulley. Refer to POWER STEERING PULLEY REPLACEMENT   . 
  3. Install the pump to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the power steering pump bolts.

    Tighten 

    Tighten the power steering pump bolts to 34 N.m (25 lb ft).

    Fig 1: Installing Power Steering Pump Bolts
    G01482910Courtesy of GENERAL MOTORS CORP.
  5. Install the return hose to the pump. Refer to POWER STEERING RETURN HOSE REPLACEMENT   . 
    Fig 2: Installing Return Hose To Pump
    G01482911Courtesy of GENERAL MOTORS CORP.
  6. Install the pressure hose to the pump. Refer to POWER STEERING PRESSURE HOSE REPLACEMENT   . 
  7. Install the drive belt. Refer to DRIVE BELT REPLACEMENT  in Engine Mechanical - 3.4L.
  8. Fill the power steering system. Refer to CHECKING AND ADDING POWER STEERING FLUID   . 
  9. Bleed the power steering system. Refer to BLEEDING THE POWER STEERING SYSTEM   . 
  10. Inspect the system for leaks. Refer to POWER STEERING SYSTEM TEST PROCEDURE   . 
    Fig 3: Installing Pressure Hose To Pump
    G01482912Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals