LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension Control System - Suspension Leveling >> Repair Instructions >> Automatic Level Control Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Install the automatic level control height sensor link onto the sensor arm.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the automatic level control height sensor to the vehicle.
  3. Install the height sensor bracket bolts (1)

    Tighten 

    Tighten the height sensor bracket bolts to 85 N.m (63lb ft)

    Fig 1: Installing Automatic Level Control Height Sensor Link Onto Sensor Arm
    G01483354Courtesy of GENERAL MOTORS CORP.
  4. Install the automatic level control height link to the tie rod ball stud. Refer to AUTOMATIC LEVEL CONTROL SENSOR LINK REPLACEMENT   . 
  5. Install the automatic level control height sensor electrical connector (1).
  6. Lower the vehicle.
  7. Perform a diagnostic system check. Refer to DIAGNOSTIC SYSTEM CHECK - AUTOMATIC LEVEL CONTROL (WITH INFLATOR)   or DIAGNOSTIC SYSTEM CHECK - AUTOMATIC LEVEL CONTROL (WITHOUT INFLATOR)   . 
    Fig 2: Installing Automatic Level Control Height Sensor Electrical Connector
    G01483355Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals