LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension Control System - Suspension Leveling >> Repair Instructions >> Automatic Level Control Sensor Link Ball Stud Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

  1. Remove the ELEC/TRAILER fuse.
  2. Raise and support the vehicle. Refer to JACKING AND LIFTING in General Information.

    Important:  When removing the link, do NOT bend or break the sensor arm.

  3. Remove the automatic level control sensor link from the tie rod ball stud.
  4. Remove the ball stud from the rear axle tie rod.
    Fig 1: Removing Ball Stud From Rear Axle Tie Rod
    G01483356Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals