LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension Control System - Suspension Leveling >> Repair Instructions >> Automatic Level Control Air Compressor Head Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Route the wires through the tie strap and the conduit.
  2. Install the O-ring (3) to the automatic level control air compressor.
    Fig 1: Installing O-Ring To Automatic Level Control Air Compressor
    G01483359Courtesy of GENERAL MOTORS CORP.
  3. Install the air compressor head.
    NOTE: Refer to FASTENER NOTICE in Cautions an on paged Notices.
  4. Install the air compressor head bolts.

    Tighten 

    Tighten the air compressor head bolts in the order shown to 6 N.m (53 lb in).

  5. Install the wiring to terminals B and C on the automatic level control air compressor electrical connector.
  6. Install the air dryer to the automatic level control air compressor. Refer to AUTOMATIC LEVEL CONTROL AIR DRYER REPLACEMENT   . 
  7. Install the automatic level control air compressor to the vehicle. Refer to AIR COMPRESSOR REPLACEMENT   . 
    Fig 2: Installing Air Compressor Head
    G01483360Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals