LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Switch Replacement - Power >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Connect the adjuster switch electrical connector.
  2. Install the adjuster switch to the finish cover.
  3. Install the finish cover to the seat adjuster.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the finish cover screws.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  5. Connect the front seat pretensioner electrical connector.
  6. Connect the front seat SIR module electrical connector.
    Fig 1: Installing Adjuster Switch To Finish Cover
    G01531951Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals