LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Adjuster Mechanism Replacement - Power >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Identifying Recliner Assembly to Side of Seat Bolts
    GM1200427Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the 2 bolts securing the recliner assembly to each side of the seat. Refer to Seat Back Recliner Replacement - Front .

    Tighten:  Tighten the bolts to 26 N.m (19 lb ft).

    2. Fig 2: Identifying Seat Cushion Frame to Power Seat Adjuster Frame Nuts
    GM1200433Courtesy of GENERAL MOTORS CORP.
  2. Install the 4 nuts that secure the seat cushion frame to the power seat adjuster frame.

    Tighten:  Tighten the nuts to 24 N.m (18 lb ft).

  3. Install the seat harness to the seat adjuster assembly.
  4. Connect the seat harness connectors to the 3 seat motors. Note the black wire routes to the front motor, the yellow wire to the middle motor, and the red wire to the rear motor.
  5. Install the SIR harness to the seat clips.
  6. Connect the gray lumbar electrical connector, if equipped.
  7. Connect the black electrical connector to the seat belt buckle.
  8. Connect the black electrical connector to the seat back harness.
  9. Install the seat cushion cover and pad. Refer to Seat Cushion Cover and Pad Replacement - Front .
    10. Fig 3: Identifying Seat Belt Buckle Assembly & Bolt
    GM1200371Courtesy of GENERAL MOTORS CORP.
  10. Install the seat belt buckle to the seat with the bolt (2).

    Tighten:  Tighten the bolt to 70 N.m (52 lb ft).

  11. Install the seat position switch. Refer to Inflatable Restraint Seat Position Sensor Replacement in SIR.
  12. Install the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  13. Install the front finish panel. Refer to Finish Panel Replacement - Front Seat - Front .
  14. Install the seat in the vehicle. Refer to Seat Replacement .
  15. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration Procedure .
scientia non olet · About LEMON Manuals