LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> Impala LS >> Repair and Diagnosis >> Quick Lookups >> Wiring Diagrams >> Wiring Systems - Introduction >> Repair Instructions >> Junction Block Replacement - Accessory Wiring >> Removal Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the left instrument panel (I/P) insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
    3. Fig 1: Junction Block & Components
    GM803447Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws from the accessory wiring junction block.
  4. Adjust the junction block for access.
  5. Remove the circuit breakers (4) and the relays from the junction block as required. Refer to Relay Replacement (Within an Electrical Center)  or Relay Replacement (Attached to Wire Harness) .
  6. If necessary remove the junction block from the bracket assembly.
scientia non olet · About LEMON Manuals