LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 559 (Wiper System And Washer System) >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiper Motor Screws, Shaft Seal & Water Shield
    GM815221Courtesy of GENERAL MOTORS CORP.
  1. Install the water shield and shaft seal onto the wiper motor.
  2. Position the wiper motor to the wiper drive system module.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the wiper motor screws.

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

  4. Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
  5. Install the wiper motor crank arm. Refer to Wiper Motor Crank Arm Replacement .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
scientia non olet · About LEMON Manuals