LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2001 >> Impala LS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Shift Interlock Systems >> Removal & Installation >> Steering Column Trim Covers >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Steering Column Trim Covers: Installation

  1. Install the upper trim cover (2) onto the steering column. Screw the 2 Torx(R) head screws (1) into the upper trim cover (2). Tighten the 2 Torx(R) head screws to 13 INCH lbs. (1.5 N.m). See Fig 4 .
  2. Install the lower trim cover onto the upper trim cover. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover. See Fig 3 .
  3. Tilt the lower trim cover up. Slide the lower trim cover forward until the locking tabs snap into the tab slots. Screw the 2 Torx(R) head screws (1) into the lower trim cover (2). Tighten the 2 Torx(R) head screws to 31 INCH lbs. (3.5 N.m). See Fig 2 .
  4. Install the tilt lever. See Fig 1 . Install the steering wheel. See appropriate STEERING COLUMNS article in STEERING. Enable the SIR system. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION.
Fig 1: Removing & Installing Tilt Lever
G00078293Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Trim Cover Screws
G00074560Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing & Installing Lower Trim Cover
G00074561Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing & Installing Upper Trim Cover Screws
G00074562Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals