Clutch Assembly: Installation
- Position clutch disc and pressure plate onto flywheel using Clutch Centering Tool (J-34860). Clutch disc is installed with damper springs facing transaxle.
- Alternately tighten pressure plate bolts evenly in a diagonal pattern to specification. See TORQUE SPECIFICATIONS . Lightly lubricate release bearing sliding surfaces and input shaft with grease.
- To complete installation, reverse removal procedure. Tighten all retaining nuts and bolts to specification. See TORQUE SPECIFICATIONS . Fill transaxle with appropriate lubricant. See appropriate MANUAL TRANSMISSION article in TRANSMISSION SERVICING.
CLUTCH SPECIFICATIONS
| Application | In. (mm) | |
|---|---|---|
| Disc Runout (Maximum) | .031 (0.79) | |
| Flywheel Runout | .004 (0.10) | |
| Minimum Rivet Depth | .020 (0.50) | |
| Standard (NEW) Rivet Depth | ||
| 1.0L | .050 (1.30) | |
| 1.3L | .060 (1.50) | |