Removal & Installation (3.8L)
WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Disconnect 14-pin connector at ignition control module. Disconnect spark plug wires from coils. Remove 6 screws retaining coils to ignition control module. Remove ignition coils from module.
- Remove ignition control module. To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS . Ensure plug wires are installed in the proper location on coils. See Figure .