LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2000 >> Chevy Express G3500, Van Passenger Extended, 4.3 W >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System Self-Diagnostics - Diesel) >> Removal & Installation >> Engine Shutdown Solenoid Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing ESO Solenoid
    GM377146Courtesy of GENERAL MOTORS CORP.
  1. Install the new O-ring on the ESO solenoid.
  2. NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  3. Install the ESO solenoid in the injection pump.

    Tighten:  Tighten the solenoid (external hex or internal hex) to 25 N.m (18 lb ft).

  4. Install the ESO electrical connector.
  5. Start the engine and check for leaks.