LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2000 >> Astro Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 794 (Anti-Lock Brake System) >> Repair Instructions >> Wheel Speed Sensor Replacement (AWD) >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The new speed sensor will have a new O-ring. Dispose of the old O-ring. Lubricate the new O-ring lightly with bearing grease prior to installation. You may also lubricate the sensor just above and below the new O-ring. Do not lubricate the bore.

  1. Install the sensor into the hub and bearing assembly (4). Tighten the sensor mounting bolts to 18 N.m (13 lb ft).

    Important:  The new sensor has new mounting clips already installed on the wire. Do not reuse the old clips.

  2. Connect the sensor electrical connector.
  3. Connect the sensor wire mounting clips to the control arm and the frame.
  4. Install the hub and rotor (5). Refer to FRONT BRAKE ROTOR .
  5. Install the brake caliper. Refer to FRONT BRAKE CALIPER .
  6. Install the tire and wheel.
scientia non olet · About LEMON Manuals