Installation Procedure

Description:

1. Install the SDM (3) to the Instrument Panel (IP) center support system (1).

NOTICE: Refer to Fastener Notice in Vehicle Damage Warnings.

2. Install the SDM mounting fasteners (2).

Tighten
Tighten fasteners to 10 N.m (89 lb in).

Description:

3. Install the SDM harness connector to the SDM.

Description:

4. Install the Connector Position Assurance (CPA) to the SDM harness connector.
5. Install the heater and A/C control head. Refer to Control Assembly Replacement in HVAC Systems with A/C Manual.
6. Install the accessory trim plate.
7. Enable the SIR system. Refer to Enabling the SIR System.