Electronic/Dual Zone Climate Controls

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable from the battery.

2. Remove the center instrument panel accessory trim plate.

3. Remove the temperature control head screws.

4. Disconnect the electrical connection.

5. Remove the control head from the vehicle.

INSTALLATION PROCEDURE

1. Connect the electrical connection to the control head.

2. Install the temperature control head.

- Tighten the temperature control head screws to 1.9 N.m (17 lb. in).

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Install the center instrument panel accessory trim plate.

4. Connect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.