LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1994 >> Lumina Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Knock Sensor Module >> Removal & Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal & Installation

  1. Disconnect negative battery cable. Remove ECM/PCM from vehicle. See ENGINE CONTROL MODULE (ECM)/POWERTRAIN CONTROL MODULE (PCM) . Position ECM/PCM so access cover faces upward. Remove access cover from ECM/PCM.
  2. Using thumb and forefinger, squeeze both ends of knock sensor module inward and pull module up from access hole. To install, reverse removal procedure. Ensure module latches into holder in ECM/PCM.
scientia non olet · About LEMON Manuals