Throttle Position Sensor (TPS) Replacement

Throttle Position Sensor:

Remove or Disconnect:
1. Disconnect electrical connector
2. Remove TPS attaching screws
3. Remove TPS

Install or Connect:
1. With throttle in closed position, install the throttle position sensor on the throttle body assembly, making sure TPS lever lines up with the TPS drive lever on the throttle shaft.
2. Coat TPS attaching screws with appropriate thread locking material
3. Tighten TPS attaching screws
Torque Value: 2.0 N-m (18 lb.in.)
4. If a new throttle position sensor was installed refer to COMPUTERS AND CONTROL SYSTEMS for TPS learn procedure.