Axle Shafts: Notes
WARNING: This page is about a different car, the 1986 Isuzu I-Mark. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
On all vehicles, raise and support vehicle with weight approved stands. Remove tire/wheel assembly.
CAUTION:
Vehicle weight must not be allowed to rest on wheel bearings and hub, WITHOUT
axle shaft installed and axle shaft nut tightened to specification.
NOTE:
Axle shafts should be disassembled ONLY to replace defective rubber boots. If boots are replaced, check all components for wear or damage and replace assembly if necessary.