Cruise Control Vehicle Speed Sensors
| Condition | Code | Procedure |
|---|---|---|
| Air gap incorrect | B | Require adjustment to vehicle manufacturer's specifications |
|
NOTE:
If a sensor is not adjustable, further inspection is required to identify and correct cause.
|
||
| Attaching hardware broken | A | Require repair or replacement of hardware |
| Attaching hardware missing | C | Require replacement of hardware |
| Attaching hardware not functioning | A | Require repair or replacement of hardware |
| Broken | A | Require replacement |
| Housing cracked | B | Require replacement |
| Internal resistance does not meet specifications | B | Require replacement |
|
NOTE:
Component failure may be caused by water intrusion into the wiring harness. Always check insulation for damage and wiring for excessive resistance.
|
||
| Lead routing incorrect | B | Require rerouting according to vehicle manufacturer's specifications |
| Loose | B | Require adjustment to vehicle manufacturer's specifications |
|
NOTE:
Some integral bearing assemblies with sensors may require replacement.
|
||
| Missing | C | Require replacement |
| Output signal incorrect | B | Require repair or replacement |
|
NOTE:
Component failure may be caused by water intrusion into the wiring harness. Always check insulation for damage and wiring for excessive resistance.
|
||
| Surface contaminated | 2 | Suggest cleaning; identify and correct source |
| Tip bent | B | Require replacement |
| Tip broken | B | Require replacement |
| Tip missing | B | Require replacement |
| Wire lead burned | A | Require replacement |
| Wire lead conductors exposed | B | Require replacement |
| Wire lead corroded | A | Require replacement |
| Wire lead open | A | Require replacement |
| Wire lead shorted | A | Require replacement |