Removal Procedure

WARNING: This page is about a different car, the 2023 GMC Hummer EV. However, it is still accessible from the selected car via links, so may be relevant.

Disable the SIR system. SIR Disabling and Enabling
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Use a flat bladed plastic trim tool to depress the steering wheel airbag access hole cover detents to remove the left and right steering wheel airbag access hole covers (1).
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Airbag Bolt (1) - Remove [2x]
Release the connector position assurance (CPA) retainer.
Disconnect the electrical connectors. (3)
Steering Wheel Airbag (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Spoke Cover Bolt (1) - Remove [4x]
Steering Wheel Bolt (2) @ Steering Wheel Shroud - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Shroud (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Radio Volume Switch (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Radio Favorites Switch (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Spoke Cover Bolt (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connectors. (1)
Courtesy of GENERAL MOTORS COMPANY

Remove the driver monitoring module (1) by unclipping the retainer clips and sliding away from the spoke cover.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connectors.
Steering Wheel Trim Spoke Cover Applique (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Bolt (1) @ Cruise Control Switch - Remove [3x]
Cruise Control Switch (2) - Remove