LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2015 >> CTS V, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System (Coupe) >> Repair Instructions >> Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement >> Removal Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal Procedure

CAUTION:

To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

  1. Place the ignition switch in the OFF position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  4. Remove the washer solvent container fasteners and position the washer solvent container aside to access the electronic brake control module (EBCM). Refer to Windshield Washer Solvent Container Replacement .
  5. Thoroughly clean the area around the EBCM of all dirt and debris.
  6. Release the EBCM electrical connector by pressing the retaining tab and rotating the locking lever forward.
    7. Fig 1: Identifying EBCM Screws
    GM2090843Courtesy of GENERAL MOTORS COMPANY
  7. Remove the EBCM screws (1).
    8. Fig 2: View Of EBCM & Brake Pressure Modulator Valve
    GM2090845Courtesy of GENERAL MOTORS COMPANY
  8. Separate the EBCM (1) from the brake pressure modulator valve (BPMV).
scientia non olet · About LEMON Manuals