LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2011 >> STS RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L - Repair Instructions >> Repair Instructions >> Crankshaft Position Sensor Replacement (AWD) >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: View Of Right Exhaust Manifold Heat Shield
    GM945964Courtesy of GENERAL MOTORS COMPANY
  3. Remove the exhaust manifold heat shield fasteners (1) and remove the heat shield (2).
  4. Remove the catalytic converter. Refer to Catalytic Converter Replacement - Right Side .
    5. Fig 2: Crank Sensor Heat Shield
    GM2743765Courtesy of GENERAL MOTORS COMPANY
  5. Remove the crank sensor heat shield retainers and the heat shield (1) to gain access to the crank position sensor.
    6. Fig 3: Locating CKP Electrical Connector
    GM887868Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect the crankshaft position (CKP) electrical connector (3).
    7. Fig 4: Identifying Crankshaft Position (CKP) Sensor
    GM1311144Courtesy of GENERAL MOTORS COMPANY
  7. Remove the crankshaft sensor fastener (1).
  8. Remove the crankshaft sensor (2).
scientia non olet · About LEMON Manuals