LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

    WARNING: Refer to SIR Warning .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the steering column shroud. Refer to Steering Column Shroud Replacement (Without Electronic Tilt Steering) or Steering Column Shroud Replacement (With Electronic Tilt Steering) .
  3. With the key installed hold it in the START position.
    4. Fig 1: Releasing/Installing Lock Cylinder Using Allen Wrench
    GM1413814Courtesy of GENERAL MOTORS CORP.
  4. Install an allen wrench into the hole on top of the ignition lock cylinder case.

    Push down on the allen wrench to release the tab on the ignition lock cylinder inside the ignition lock cylinder case.

    5. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  5. Slide the ignition lock cylinder out of the ignition lock cylinder case.
scientia non olet · About LEMON Manuals