LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2008 >> XLR Base >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: View Of DIC Switch Pod
    GM1224702Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition switch into position on the DIC pod.
    2. Fig 2: View Of Ignition Switch & Electrical Connector
    GM1224598Courtesy of GENERAL MOTORS CORP.
  2. Connect the ignition switch electrical connections.
    3. Fig 3: View Of DIC Switch Pod
    GM1224702Courtesy of GENERAL MOTORS CORP.
  3. Install the DIC switch pod. Refer to Driver Information Display Switch Replacement .
  4. Install the driver knee bolter trim panel. Refer to Driver Knee Bolster Panel Replacement .
    5. NOTE: Refer to Fastener Notice .
  5. Connect the negative battery cable.

    Tighten:  Tighten the cable bolt to 15 N.m (11 lb ft).

scientia non olet · About LEMON Manuals