LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> CTS V6-3.6L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Knock Sensor >> Service and Repair >> Knock Sensor Replacement - Bank 1
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Knock Sensor Replacement - Bank 1



Knock Sensor Replacement - Bank 1

Removal Procedure




1. Turn the ignition OFF.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Reposition the wiring harness heat shield to obtain access.
4. Remove the knock sensor (KS) electrical connector.




5. Remove the KS bolt.
6. Remove the KS.

Installation Procedure




1. Install the KS.

Notice: Refer to Fastener Notice.

2. Install the KS bolt.

Tighten the KS bolt to 23 N.m (17 lb ft).




3. Install the KS electrical connector.
4. Install the wiring harness heat shield to the original position.
5. Lower the vehicle.

scientia non olet · About LEMON Manuals